Use a short certified data cable in the projection port, unlock the phone and accept the connection prompt. Change one variable at a time and keep the original data or settings safe.
Use normal shutdown procedures, keep hardware dry and stop if you see damage, overheating, burning smells or any electrical risk.
Checks to perform in the right order
Confirm the exact symptom
Separate charging without data from a missing phone and a projection session that drops.
Check the relevant setup
Check the data USB port, cable and authorisation prompt on the phone.
Run one controlled test
Test one phone with a known-good data cable and no hub or adapter.
Compare the result
Repeat the test with one compatible cable, account, network or accessory changed. A controlled comparison shows whether the fault follows the device or the environment.
Escalate with evidence
Record the exact model, software version, warning and result of each safe check. Use the manufacturer's support page before deleting data or opening hardware.
How to narrow down the cause
- A change after one controlled test is a useful clue; keep the other variables unchanged.
- If a second compatible device works in the same setup, focus on the first device rather than replacing everything.
- Stop if there is heat, liquid, physical damage, burning smell or electrical risk.
Official sources used
Procedures can vary by model, firmware or hardware revision. When your device differs, use the official manufacturer documentation for that exact model.